16
17
18
Assembly - BiG400 Garage Space Saver
Slide the racking against
the wall and check that the
racking is level ensuring that
all beams have been tapped
down all the way in
If not level then
fit shims
G
under
corresponding feet
With the racking in position mark the
fixing positions against the wall and floor
Drill marked positions and refit racking
securing at all points
Fit the chipboard
F
to all levels
Fit the wall tie
J
by inserting the
lugs into the key-
holes and tapping
down with a rubber
mallet
Note: Illustrations not to scale
The information contained in this leaflet was accepted as correct at the date of publication. However, the manufacturer reserves the right to make any necessary
changes, in line with the product development and improvement. Although all reasonable care has been taken to make it as complete wand accurate as possible, no
liability can be accepted for any inaccuracies or omissions.
Loading information
BiG400 Garage Space Saver
These load charts relate to shelving with the following specifications:
n
1830mm High
n
2134mm Wide
n
610mm Deep
n
with lower level incomplete
For any other layouts, please refer to your supplier for detailed loading capacities
Shelf Load Capacities
The maximum load permitted is 1000 kg. Maximum permitted shelf capacities are based on uniformly distributed loads
(UDL). Please note that the above bay capacity may limit the maximum load per bay:
IF YOU ARE IN ANY DOUBT REGARDING LOAD CAPACITIES, PLEASE CONTACT YOUR SUPPLIER
Accessories
If bought with plastic boxes please ensure to leave
adequate height
Shelf width mm
Capacity with 15mm Chipboard decks
2134
400kg
Capacities are common for all standard shelf depths.
BiG400 Garage Space Saver is safe when used responsibly. If in doubt, contact your supplier
J
13
14
15
G
F
