Shenzhen BIGTREE technology co., LTD.
BIG TREE TECH
Notes:
1. When using 12864 screen mode, connect the port EXP1 and EXP2 to the
motherboard. (If user uses the SKR MINI E3 or SKR E3 DIP, just connect
EXP3 to the motherboard.)There is no touch function in this mode.
2. When using serial port screen mode, connect with TFT or aux-2 on the
motherboard via RS232. This mode has touch function
；
3. Two work modes can be changed by one key. Press the encoder about 3
seconds until the mode selection page appears, then press the encoder
after selecting the mode.
IV. Firmware Introduction
Factory board will be equipped with test firmware, it can be used directly.
User can also change the firmware according to their own need.
1. Ways to obtain the firmware of motherboard
1)Get it from customer service or technical staff
2)Log in the open source website of our company to download:
https://github.com/bigtreetech
2. Firmware update
Firmware file name
：
BIGTREE_TFT35_V3.0.(version number).bin
First copy the above firmware to SD root directory, and then insert the card into the
SD card slot of the board. Next please re-power the board or press the reset key, and
wait for about 10 seconds before the update is completed.
3.For DIY board firmware, please refer to the file TFT35-V3.0-PIN.
V. Notes
1.The name of the firmware file in the SD card cannot be changed. (including capital
and small letters)
2.Wiring process must be under the precondition of power outages. Users must
check the correct connection of the circuit and the correct insertion of the drive
module before turning on electricity. Pay attention to the wiring sequence and do
not insert the wire inversely. Please refer to PIN file for detailed line order.
If you meet other problems in the use, you are welcome to contact us, we will
answer for you carefully. If you have any good comments or suggestions on our
products, you are welcome to give us feedback, and we will carefully consider your
comments or suggestions. Thank you for supporting BIGTREETECH products.
