background image

Wi-Fi Setup 

If using the Wi-Fi connection, follow these instructions 

Step 1)

Plug in the included power cable to the PDU and to the AC mains outlet on the wall. 

a) Wait approximately 15-30 seconds, the power button will begin to flash.

Step 2)

Scan for Wi-Fi on your Wi-Fi enabled device with a web browser 

Step 3)

Connect to the Wi-Fi SSID of the PDU 

a) The SSID of the PDU will be “Metra-xxxxxxxxxxxx” where the “x” are the MAC address or device ID of the PDU.

i) Verify the code of the SSID matches the MAC address of the PDU with the Sticker that is attached to the bottom of the

PDU.

Step 4)

In a web browser go to “192.168.4.1” 

Step 5)

Go to “Network” 

Step 6)

Click “SCAN NETWORKS” 

a) The network mode can also be changed before scanning. For ease of setup we’ll use the default DHCP settings.

Step 7)

Select the desired network SSID 

NOTE: the PDU requires a 2.4Ghz Wi-Fi connection. 

Step 8)

If required enter the password for the Wi-Fi connection 

Step 9)

Click “Save” 

a) The PDU will now connect and reboot. After it has rebooted it will attempt to connect to the Wi-Fi signal.

Step 10)

Once the PDU has been connected to the network and has access to the web, proceed to the next steps 

Cloud setup 

Step 1)

Log in to your MAVbase.com account 

Step 2)

Click the Add New button 

a) Then click “ADD PDU”

Step 3)

Add the PR-W3PI to your account using the MAC address of the PDU 

Surge Protection 

Protected Circuit(s) 

Internal 2380 Total Joule Protection from the Line to Neutral circuit. 

IMPORTANT SAFETY INSTRUCTIONS 

Summary of Contents for MAVbase PR-W3PI









Reviews: