- 4 -
Operation
Before the First Use
IMPORTANT!
• Never fill more than a total of 1.3 litres of tap
water into the water container. The minimum
quantity in the water container and the minimum
quantity of brewed coffee in the glass coffee-pot
is 250 ml. Otherwise the coffee maker could be
damaged.
• Disconnect the coffee maker from the power sup-
ply immediately after use. The coffee maker is
only fully currentless when you pull the plug out
of the wall socket.
• Only pour tap water into the water container.
Otherwise you may damage the coffee maker.
• open the glass coffee-pot
u
and the water
contaier.
• Carefully rinse the water container and the glass
coffee-pot with tap water.
• Fill the glass coffee-pot with max. 1.3 litres of tap
water.
• Pour all the tap water into the water container
(fig.C).
• Place the empty glass coffee-pot onto the
hotplate.
• Switch the coffee maker on and wait until the
coffee-making procedure has finished.
• Empty the glass coffee-pot.
• Switch the coffee maker off by pressing the
mains switch again
t
, until the power on light
goes out.
Then you can use the coffee maker to make fresh
coffee.
Fill in ground coffee
• Swing out the filter holder
q
(fig. D).
• Place an opened size 4 paper filter into the filter
holder. (First fold the bottom filter paper edge
over)
• Fill the ground coffee into the paper filter.
Allow approx. one level coffee measure per
small cup of ground coffee. For large cups, al-
low approx. one heaped coffee measure per
cup. If the coffee is too strong, you can reduce
the amount of ground coffee per cup to taste.
• Close the filter holder.
Fill water
• Open the water container lid
i
.
• Fill the glass coffee-pot
u
with tap water.
• Pour the tap water for the amount of coffee
required into the water container (fig.C).
• Close the water container lid
i
.
Switching on and off
• If you wish to switch on the coffee maker, press
the power switch
t
, until the red pilot lamp
lights up.
• If you wish to switch off the coffee maker, press
the power switch until the pilot lamp goes out.
• Then pull the power plug out of the wallsocket.
Wind up the cord
• Push the cord into the cord compatment on the
back of the machine (fig.B).
• If necessary, push the metal contact
of the plug into the holes above the cord com-
partment.
IB_KH1112_E3340_LB6 22.02.2008 9:28 Uhr Seite 4
