27
1.5
24
65
3
24
65
Installation, Operation and Maintenance Manual
MAN 564_EAC Rev. 2
June 2020
Operation and Use
Section 3: Operation and Use
4
3
2
1
c1
c2
For the adjustment of the mechanical stop on the end flange of hydraulic cylinder of MHP,
follow these steps (Figure 30):
•
Remove with the specific wrench (c1) the plug (t).
•
Insert a wrench for Allen keys (c2) in the through hole until reaching the
adjustment pin (g).
•
Keep the protection cover blocked with the special wrench (c3).
•
Turn counter-clockwise to increase the angular stroke, turn clockwise to decrease it.
•
When the adjustment is over tighteen the plug (t).
Figure 29
Optional (if foreseen)
Figure 28
Mechanical stop on the end flange of manual override
GIG actuator size
Wrench c1 (mm)
Wrench c2 (mm)
Table 12.
