5
5.1 Cautions
5.1.1 Protect the pump and controller from rain and moisture and minimise exposure to
extremes of heat and cold. Operating range 2
o
C - 40
o
C.
5.1.2 The pump is designed for use with clean water. Contamination including sand or
mineral deposits may affect the operation of the pump and controller.
5.1.3 The pH of the water must be between 6.5 and 8.5.
5.1.4 This pump is not suitable for use with spa or pool water.
5.1.5 Running the pump without water or allowing the pump to run dry will damage the
mechanical seal and void the warranty.
5.1.6 Avoid situations where the pump could be exposed to corrosive liquids or gasses, or
to flammable materials, solvents etc.
5.1.7 Fitment and replacement must be carried out by competent, skilled and qualified
personnel.
6. Standards and Approvals
SAA Approvals
is accredited by the Joint Accreditation
Service of Australia and New Zealand (JAS-ANZ) as a third
party certification body to issue of Certificates of Approval for
declared and non-declared electrical equipment that has
proven to comply with the safety requirements of the
applicable Australian Standard.
Pumps that carry the AS/
NZ4020 Drinking Water Approval
demonstrate compliance with requirements of Australia &
New Zealand Standards of products that come into contact
with water intended for human consumption. This approval
also ensures that the water coming from the pump will not be
contaminated by toxic materials or metals. It also means the
water will not support the growth of micro-organisms and will
not cause a change in taste or appearance.
CE marking
is a certification mark that indicates conformity
with health, safety and environment. The CE marketing
represents a manufacturer’s declaration that products comply
with the EU’s New Approach Directives. These directives not
only apply to products within the EU but also for products that
are manufactured in or designed to be sold in the EEA.