A:
9300 Gemini Drive, Beaverton, OR 97008
T:
+1 877.242.6796
W:
www.biamp.com
Installation Option – Tabletop Mounting with Grommet
1. Cut a 5/8 inch (16 mm) hole through the tabletop where the cable is to be
routed.
2. Set the microphone on the table and run the cable through the hole.
3. Snap the two grommet pieces together around the cable and install in the
hole.
4. Attach the microphone connector into the RJ-45 socket on the face of the
network box.
Figure 7 Tabletop with Secure-Mount Installation Option
Figure 6 Tabletop with Grommet Installation Option
Installation Option – Through Tabletop with Secure Mount*
1. Cut a 5/8 inch (16 mm) hole through the tabletop where the table
microphone is to be located.
2. Place the Secure Mount stem onto the bottom of the microphone making
sure the slots are aligned and attach with the included screws.
3. Pull the microphone cord out of the slot on the microphone and push it into
the opening on the stem of the Secure Mount.
4. Feed the cable through the hole in the table.
5. Install the stem throught the hole in the table.
6. Secure the microphone mount with the retaining hardware (slotted nut) on
the underside of the table.
7. Attach the microphone connector into the RJ-45 socket on the face of the
network box.
*
Sold separately
Figure 5 Grommet
TTM-X MICROPHONE
DRILL 5/8” (16 MM)
DIA. HOLE THROUGH
TABLETOP
SECURE MOUNT STEM
ETHERNET CABLE
SECURE MOUNT NUT
CAUTION: If removing the grommet, use a punch or
other appropriate tool and push the grommet out from
beneath the table to avoid damaging the table surface.
