Devio SCX
Installation and Operation Guide
page 3
Devio SCX Installation Cont.
Biamp Launch is an intuitive easy-to-use feature that automatically identifies
devices and adjusts audio settings and parameters based on measurements
taken during the Launch process.
Biamp Launch may be initiated from the Launch button on the Audio page
of the embedded user interface or from the Launch button on the front of the
device itself. See the following steps to Launch the SCX:
1. Connect all devices making sure that the speaker(s) and microphone(s)
are at least three feet apart.
• To Launch from the SCX device, press the Launch button at the
front panel. The speakers will request for the button to be pressed
again. A recorded announcement (English language) advises the
user that the automated process is about to begin and when the
process is finished.
• The device IP address is required to access and Launch the Devio
SCX from the embedded web interface. Click
to download the
Biamp Discovery tool and access the IP address.
Choose the Target SPL dB and UC Vendor from the drop down and
click Launch:
2. A recorded announcement (English language) advises the user that the
automated process is about to begin and the Launch button indicates that
the Launch is in progress:
Figure 5 - Launch
Figure 6 - Launch Running
3. During the Launch process the speakers will emit numerous chirps/sweeps
to indicate the SCX is measuring the following:
• Room acoustics
• Distance between mics and speakers
• Speaker frequency response
• Audio level (SPL) for listeners in the room
4. Once the launch process is successful, the SCX will use the
measurements to adjust various system parameters, including the output
volume level to achieve the desired target SPL. The parameters adjusted
are listed below:
• Output (speaker) level control - to achieve target SPL
• Output (speaker) limiter - to prevent exceeding max SPL
• Parlé processing block parameters
• Room acoustics (fair/good/great)
• NLP level
• Noise reduction
5. If Biamp Launch fails, the block parameter adjustments may not be
applied. In either case another recorded announcement will be played at
the end of the process providing status information:
6. Upon successful launch, a report card is generated that gives information
about the room acoustics and adjustments made during the Launch. Click
the Report button to review the report card:
Figure 7 - Launch Failed
Figure 8 - Launch Report
