page 2
Installation and Operation Guide
MASK2
MOUNTING THE SPEAKER
1. Point the center of the speaker at
the center of the listening area.
2.
Test fit the speaker on the
bracket to ensure the desired
angle (see Step 7) before
mounting the bracket on the
wall.
3. Using the bracket as a
template, drill the mounting
holes as shown in Figure 1.
Note:
The base plate may be rotated by 45 or 90
degrees to get the maximum tilt angle in the desired
direction when installing in a corner.
4. If the speaker location is pre-wired, thread the wiring
through one of the four pre-cut cable entries on the
bracket base prior to mounting the bracket (Figure 2).
5. Mount the bracket to the surface (Figure 3). The
mounting materials for solid brick walls are included.
6. Tighten all the screws and cover with the screw
covers (Figure 4).
7. Determine the angle of the speaker by adjusting
the bracket base and the H-hook on the half-sphere
ball. The H-hook can be adjusted with or without the
speaker attached to the hook. Adjust the turning force
of the H-hook by tightening or loosening the central
screw (Figure 5).
8. Slide the rubber security piece (a) out from the back
of the speaker and slide the speaker on to the H-hook
(b) on the mounting bracket. Slide the rubber piece
back in place to lock and secure the cabinet
(Figure 6).
9. Remove the euroblock connector (a) from the
speaker and connect the speaker wires (b)
maintaining the polarity marked on the back of the
speaker: + is positive, - is negative (Figure 7).
Fully insert the bare portion of each wire into the
connector. Maintain the same color code for all of the
sound system wiring from amplifier to loudspeakers.
Note
: For distances up to 20 meters, 0.75 mm²
(18AWG) speaker wire can be used without loss of
performance. For longer distances use thicker wire.
b
a
Figure 6.
Attach speaker to
bracket
Figure 7.
Connect speaker
wires
Figure 2.
Guide speaker
wiring through
bracket base
Figure 3.
Mount the
bracket
Figure 4.
Tighten the
screws and
insert covers
Figure 5.
Adjust speaker
and bracket
a
b
Screw Cover
Mounting Holes
Figure 1.
Drill mounting holes
