A:
9300 S.W. Gemini Drive Beaverton, OR 97008 USA
T:
+1 503.641.7287
W:
www.biamp.com
JUNE 2019
3. Locate
Pressing the locate button will play an audible signal that cycles through
each connected output.
4. Amp Status
A multi-color LED provides information about the status of the amplifier.
Status
LED Indicator
No Power
Off
Clip detected
Red Solid
Amplifier limiter engaged
Yellow Solid
Powered
Green Solid
Amplifier is in Locate mode (triggered from the software)
Green Flashing
Amplifier has failed to initialize, an error is present, or the
amp is temporarily muted due to an audio burst
Red Flashing
PoE+ power is not available or insufficient to power the
amplifier so it has been turned off
Red/Yellow Flashing
5. Outputs 1-4
RJ-45 speaker connections. 4 x 3W RMS or 2 x 7W RMS or 1 x 15W RMS
output at low impedance 4Ω/8Ω.
Front Panel and Connectors
1. AVB/Control
Facilitates connection to the Tesira AVB network for audio and control. This
RJ-45 port may either be connected directly to the Tesira AVB port (via a
PoE+ injector) for a single device system or via a PoE+ network switch in a
multi-device AVB system. IEEE 802.3at Power over Ethernet Plus (P0E+)
Class 4 is required as there are no other provisions for power inlet.
2. Power/System LED Status Indicator
A multi-color LED provides information about the status of the device
Status
LED Indicator
No Power
Off
Powered but not ready to receive configuration
Red Solid
Ready to receive configuration or updating firmware
Yellow Solid
Configured and ready to participate in the system
Green Solid
Amplifier is in Locate mode (triggered from the software)
Green Flashing
Unit has a Major Alarm condition
Red Flashing
Unit has a Minor Alarm condition
Yellow Flashing
Unit has both a Major and Minor Alarm condition
Red/Yellow Flashing
