4
| Amplified Loudspeaker Controller Install and User Guide
EC Declaration of Conformity
Biamp Systems, LLC
9300 S.W. Gemini Drive
Beaverton, OR 97008
USA
We declare that under our sole responsibility the products:
Model Names:
ALC-404D
ALC-1604D
ALC-3202D
Intended use:
Professional Audio Amplifier
Are in conformity with the provisions of the following EC
Directives, including all amendments, and with national legislation
implementing these directives:
2014/35/EU Low Voltage Directive
2014/30/EU Electromagnetic Compatibility Directive
2011/65/EU RoHs Directive
The following harmonized standards are applied:
EN 55032:2012,
EN 55032:2012/AC:2013
EN 55035:2017
EN 61000-3-2:2014
EN 61000-3-3:2013
EN 61000-3-11:2000
EN 62368-1:2014
EN 62368-1:2014/AC:2015
Complies with:
CAN/CSA-C22.2 No. 62368-1:14
UL 62368-1 2nd Ed."
Regulatory Compliance Statements
Europe
If the time arises to dispose of your product, please recycle all possible
components.
This symbol indicates that when the end-user wishes to discard
this product, it must be sent to separate collection facilities for
recovery and recycling. By separating this product from other
household-type waste, the volume of waste sent to incinerators
or land-fills will be reduced and natural resources will thus be conserved.
The Waste Electrical and Electronic Equipment Directive (WEEE
Directive) aims to minimize the impact of electrical and electronic
goods on the environment. Biamp comply with the Directive 2012/19/
EU of the European Parliament on waste electrical finance the cost
of treatment and recovery of electronic equipment (WEEE) in order to
reduce the amount of WEEE that is being disposed of in land-fill site.
All of our products are marked with the WEEE symbol; this indicates that
this product must NOT be disposed of with other waste. Instead it is the
user’s responsibility to dispose of their waste electrical and electronic
equipment by handing it over to an approved reprocessor, or by returning it
to Biamp for reprocessing. For more information about where you can send
your waste equipment for recycling, please contact Biamp or one of your
local distributors.
USA
FCC Supplier’s Declaration of Conformity
Responsible Party:
Biamp Systems, LLC
9300 S.W. Gemini Drive
Beaverton, OR 97008 USA
biamp.com
FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions:
1) This device may not cause harmful interference, and
2) this device must accept any interference received, including interference
that may cause undesired operation.
CAUTION:
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE:
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit
•
Different from that to which the receiver is connected.
WARNING:
This is a class A product. In a domestic environment this product
may cause radio interference in which case the user may be required to
take adequate measures
Canada
Canadian Caution
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-
exempt RSS(s).
Operation is subject to the following two conditions:
1)This device may not cause interference.
2)This device must accept any interference, including interference that
may cause undesired operation of the device.
WARNING:
This is a class A product. In a domestic environment this
product may cause radio interference in which case the user may be
required to take adequate measures
L’émetteur/récepteur exempt de licence contenu dans le présent appareil
est conforme aux CNR d’Innovation, Sciences et Développement
économique Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
1)L’appareil ne doit pas produire de brouillage;
2)L’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
AVERTISSEMENT:
Ce produit est un produit de classe A. Dans un
environnement domestique, ce produit peut provoquer des interférences
radio, auquel cas l’utilisateur peut être amené à prendre des mesures
adéquates.
ICES-003 Class A Notice - Avis NMB-003, Classe A
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003
du Canada.
Radiation Exposure Statement
This equipment complies with RSS-102 radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator & your body.
Énoncé d’Exposition à la Radiation Ic
L’appareillage répond aux limites de la norme RSS-102 sur l’exposition
aux radiations établies pour un environnement non-contrôlé. Il devrait être
installé et fonctionner à une distance minimale de 20 cm entre l’antenne et
votre corps.
ALC-404AN
ALC-1604AN
ALC-3202AN
