Bi-Bright iRed+, Manual, Page: 15 / 20

STEP 1 - Users can calibrate image by opening the calibration tool (according to your computer
operating system) that is stored in the IWB SD Card (or in the supplied CD – depending on your
iwb version). For Windows 7 and 8 we recommend calibrating the interactive whiteboard with the
Windows native tool “Tablet PC definitions” The image must be all inside the whiteboard surface
to be able to make the calibration.
STEP 2 - After opening this program the following point of calibration will appear.
STEP 3 - Press in the centre of each calibration point.
STEP 4 - The Calibration is complete.
If the calibration does not complete successfully, please check that there is nothing blocking the
IR signal in the IWB surface. The surface must be completely empty, meaning, nothing can be on
it. Moreover, the projector image must be completely inside the white surface. Please leave at
least 1cm distance between the projector image and the board frame (along the 4 sides). If still
unsuccessful go back to step 1.
Plug & Play
Set-up
Calibrating
No driver installation needed for running the IWB, just connect the computer. The Interactive
Whiteboard is recognized as an HID device, once connected to the computer. Depending on the
features of your computer, you may be requested to restart it.
Before initiating the calibration process always press the Reset button if it is active, as it will
most likely indicate that your pc was connected to a different multi touch device.
15 Set-up/Calibrating