6
INSTALLATION
WIRING
PLEASE NOTE.
The positive and negative supply from the battery and the red and black cables to the
winch must be a minimum of 6mm
2
cross section to avoid any voltage drop. A minimum of 8v through the
system must be maintained. The positive and negative terminals on the winch PCB are shown above.
A 16amp auto cut out / reset button linked into the positive supply from the battery is recommended by
Bushey Hall Winchmaster for these systems, although a 30amp fuse can be used instead. The auto cut out
or fuse is normally mounted under the dashboard, or inside the bonnet, close to the battery for ease of
access.
The radio remote control and automatic webbing strap cut out calibration should is already set at the factory
before supply.
However, If radio remote requires pairing or the webbing strap cut out needs calibration the following
processes should be followed:
PAIRING THE CONTROLLER
To pair the controller(s) to the winch PCB, press any button on the controller.
Then press the pair button on the winch PCB:
