I LY N X T R A I L C A R B O N
2 0 2 2
BH 11
C
D
A
B
E
0 6
P E D A L A S S I S T A N C E S Y S T E M O P E R A T I O N
C O M P O N E N TS O F T H E P E D A L A S S I S TA N C E S YS T E M
The BH Bikes pedal assistance system is made up of the following components:
•
A.
A
motor
, which drives the bicycle.
•
B.
A
control panel
(I-REMOTE), which, among other things, allows you to select the assistance mode.
•
C.
A
battery
, which powers the motor and can be located in different places.
•
D.
A
torque sensor
, which reads the force applied to the pedal by the user.
•
E.
An optional
external battery
to increase the standard range.
P E D A L A S S I S TA N C E S YS T E M
The pedal assistance system is designed to provide the optimal amount of assisted power. It provides assistance
within a standard range, based on factors such as the pedalling force, the speed of the bicycle and the transmission.
The system does not provide assistance in the following situations:
•
If the control panel is off.
•
When travelling at 25 km/h or faster.
•
If you are not pedalling and the throttle function is released at 6 km/h.
•
If there is no remaining battery capacity.
•
If the assistance mode selected is 0% assistance.
PA RTS O F T H E C O N T R O L PA N E L
The i-Remote or general control panel is located on the left side of the handlebars, next to the grip. The control
consists of 4 parts:
S W I T C H I N G T H E P E D A L A S S I S TA N C E S YS T E M O N A N D O F F
The pedal assistance system is turned on from the i-Remote (central control panel). It is located next to the left grip
on the handlebars. Press the power button to start the system. The 4 LEDs will be activated one at a time and lit
blue to indicate that it has been turned on. The LEDs will change colour immediately after, showing the current pedal
assistance mode. If the battery has been removed from the frame and put back into its position, the system will also
turn on, first showing the same blue LED (see the section "Releasing and removing the battery").
To turn off the pedal assistance system, press and hold the power button for 3 seconds. The LEDs will turn off and
the system will then shut down.
After turning the system on, make sure that you do not start riding without checking the assistance mode.
By default, it starts with the assistance mode selected before it was last switched off.
Wait for 3 seconds after turning on the system before you start applying pressure on the pedals. During this
3-second period, the assistance system is starting up and calibrating the torque sensor. Otherwise, if you
press the pedals beforehand, this may reduce the effectiveness of the assistance system and error 14 may
even be displayed on the screen (see the "Error code" section). To fix this, you should reboot the system
without applying pressure to the pedals for the 3-second period.
L E D S
P O W E R B U T T O N
+ B U T T O N
- B U T T O N
06
P E D A L A S S I S TA N C E S YS T E M O P E R AT I O N
Summary of Contents for iLYNX TRAIL CARBON 8.6
Page 35: ...w w w b h b i k e s c o m...
