T7 Treadmill
BH Fitness • 20155 Ellipse • Foothill Ranch • CA • 92610
www.bhfitness.com • Phone 949-206-8152 • Fax 949-206-0013
12
MAINTENANCE
ADJUSTING THE BELT
If your unit is not seated evenly on the four contact points, this may cause the belt shown on
Figure 8, area (X) to shift sideways. Rigorous quality control adjusts and checks the running
belt. However, due to weight differences and individual styles of running, the belt may be prone
to shift sideways.
If the belt does shift to the left or right, stop the machine and adjust the belt.
NOTE:
Over tightening of the belt can lead to a loss of speed on the machine and even stretch
the belt itself. Bear In mind that one turn of the right screw (R) in a clockwise direction has the
same effect on the position of the belt as one turn of the left screw (L) in a counterclockwise
direction. Consequently, in the event of excessive belt movement you can use either of the two
screws in order to avoid over tightening the belt.
BELT SHIFTED TO THE RIGHT (Figure 8)
1. Turn off and unplug the treadmill each time before using the hex wrench.
2. Use the hex wrench to turn the right hexagonal head socket a 1/4 turn clockwise.
3. Turn on treadmill for a few minutes at a speed of 2.5 mph (4 km/h) and check belt location.
4. If the belt is not centered, then turn the left hexagonal head socket a 1/4 turn
counterclockwise.
5. If the belt is not centered, then repeat steps.
BELT SHIFTED TO THE LEFT (Figure 8)
1. Turn off and unplug the treadmill each time before using the hex wrench.
2. Use the hex wrench to turn the left hexagonal head socket a 1/4 turn clockwise.
3. Turn on treadmill for a few minutes at a speed of 2.5 mph (4 km/h) and check belt location.
4. If the belt is not centered, then turn the right hexagonal head socket a 1/4 turn
counterclockwise.
5. If the belt is not centered, then repeat steps.
TREADMILL CLEANING
Switch the unit off and unplug the power cable. Use a damp cloth or towel to clean the dust off
the treadmill, especially the side bars and the electronic console. Do not use solvents.
NOTE: Unplug the treadmill before using a vacuum near the treadmill.
Use a vacuum cleaner to carefully vacuum around the visible components (belt, structure,
etc.). You can increase the INCLINE in order to vacuum the underside of the unit. You can
vacuum the inside of the motor housing by removing the cover that protects the motor (be
careful with the wires).
NOTE: Press STOP to lower the INCLINE.
