BH FITNESS R320, Instructions For Assembly And Use

Page: 12 / 39

12
Insert the seat travel stops by
mounting screws (40) together with
the end caps (26) and then firmly
tighten with the 6mm Allen wrench.
Mount end caps (21) and (22) at the
end of the aluminium rail as shown in
Fig.2.
6.- MOUNTING THE REAR
SUPPORT.-
Position rear support (3) on the bottom
of rail (2), Fig.3. Insert screws (38)
and washers (39) and then firmly
tighten with the 6mm Allen wrench.
7.- WOOD COVERS
ASSEMBLY.-
Release the end caps (96) with the
screws (38) along the washers (98) as
shown in fig 4. and fix them on the
side covers (95) and (99) as shown in
fig 5 eith screws (97) along the
washers (98) and nuts (58).
Then place the wood lateral covers
(95) and (99) as shown in fig 5. And
tighten with screws (38) and (101)
along the washers (98).
Finally place the back cover (100)
tighten with screws (82) as shown in
fig 6.
LEVELLING.-
Once the unit has been placed into its
final position for doing exercise, make
sure that it sits flat on the floor and
that it is level. This can be achieved by
screwing the adjustable support
blocks (24) up or down, as shown in
Fig.8.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (14)
to make it easier to move. The wheels
located at the front of your unit make it
easier to move it into a chosen
position, by lifting the rear of the unit
up slightly and pushing it, as shown in
Fig.7. Store your unit in a dry place,
preferably not subject to changes in
temperature.
MAINS CONNECTION.-
Insert the jack (m) for the transformer
into the connection hole on the main
body (k) (bottom, rear of the machine)
and then plug the transformer (79) into
a 230 V mains supply, Fig.8.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE