BH FITNESS G540, Instructions For Assembly And Use

Page: 14 / 17

14
Position the footrest support plate (4)
on the footrest (3), attach it using
screws (29) along with the washers
(31) and nuts (32), Fig.2.
Perform assembly procedures similar
to the right footrest support (1), for the
left footrest support (2) Fig.3.
3.- FITTING THE UPPER &
LOWER CROSSBARS.-
The assistance of a second person is
recommended for this stage of the
assembly.
Take the right foot (1) assembly,
position the crossbar for the upright
tube (15), Fig.4, fit the crossbar
holding plate (26) and secure using
screws (20) washers (21) and nuts
(22), Fig.4.
Next, position the foot support
crossbar (16), Fig.4, fit the crossbar
holding plate (26) and secure using
screws (20) washers (21) and nuts
(22), Fig.4.
Having fitted the crossbars to
assembly (1), position the left footrest
assembly (2), Fig.5, fit the crossbar
holding plate (26) and secure using
screws (20) washers (21) and nuts
(22), Fig.5.
4.- FITTING THE ARMREST
SUPPORTS.-
Insert the armrest support (6) into the
footrest support (1) in the direction of
the arrow, Fig.6. Position the crossbar
(10) and fit the screws (20) along with
the washers (21) and the nuts (22) but
only hand tighten the nuts.
Next, insert the armrest support (6)
into the footrest support (2) in the
direction of the arrow, Fig.6.
Insert screws (20), along with washers
(21) and nuts (22), and tighten
securely.
You should also tighten the screws
fitted in the previous step.
5.- FITTING THE HOLDING
BRACKETS.-
Place the holding brackets (13) onto
the footrest supports (1) & (2), Fig.7,
and to the bottom of the armrest
supports (6), Fig.7.
Insert screws (24), along with washers
(21) and nuts (22), and tighten
securely.
6.- ATTACHING THE EXERCISE
BAR.-
Place the exercise bar (7) alongside
the armrest supports (6), Fig.8, fit the
corrugated washers (30) along with
screws (28), Fig.8, and tighten
securely.
7.- FITTING THE BACKREST &
ARMRESTS.-
Position the backrest (11) on the
backrest crossbar (10), Fig.9, secure
using screws (28) along with washers
(21).
Next, position the armrest (12), Fig.9,
and secure them by using screws (25)
along with washers (21).
INSPECTION & MAINTENANCE.-
Check and tighten all the parts on your
unit every three months. If you are
unsure about the condition of any part,
we recommend that you replace it with
original spare parts. The use of other
spare parts may cause injuries or
affect the performance of the machine.
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.