BGU KSA 380 E, Original Instruction Manual

Page: 24 / 40

Seite 24
12. Trouble-shooting chart
The following section will detail procedures for checking your processor, should you encounter a malfunction.
Important!
Before setting, operating, cleaning, maintaining or repairing the processor, read the manufacturer’s opera-
ting and maintenance instruction manual.
Trouble description Possible causes Remedies
Processor fails to split - no or low oil - Check the oil and fill up, if required
- Multifunctional control lever is not - Reset lever trigging mechanism
properly shift down to last step
- Control valve out of setting - Provide new adjustment
- There is dirt of the trigging system - Clean
- Oil is too cold - Let the processor run a few minutes
till oil has warmed up
Splitter push-block - Oil is too cold - Let the processor run a few minutes
slides too slowly or till oil has warmed up
powerless - No or low oil - Check the oil level and eventually fill-up
Splitter cannot - Wrong setting of the wedge - Make sure the wedge is set properly
complete splitting of -Crooked, very branchy unpruned log - Switch the machine off and turn the log
around to find optimal position inside
the splitter trough
- Log diameter is too big - Switch the machine off and remove log
- Operating pressure is too low - Check and set the hydraulic system
Oil warms up - Not enough oil in the line - Check oil and eventually fill-up
- Ram does not slides back - Check and reset ram stroke-end
Log pops up during - Very branchy unpruned log - Stop the machine, disconnect power
splitting
The electric motor does - Faulty power cable - Check cable status
not start - Faulty protection fuse - Replace fuse
- Faulty switch - Replace switch
- Broken motor - Replace motor
- Emergency stop push-button pressed - Press to release
down
The electric motor turns - Inverted wires in power cable - Change plug polarity
but in the wrong direction (using a phase changer)
Conveyor belt slips to - Check stretching - Eventually re-tension (adjust upper
the side
the side pulley)
Log sticks to the wedge - Wedge knives are dull - Re-grind
after splitting
Logs don‘t get caught - Belt conveyor position is excessively - Adjust rake angle (reduce conveyor
by belt conveyor upright upright slope)