BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
BGS 3521
Wishbone Lever
INTENDED USE
This wishbone lever is used for comfortable, safe pressing down and holding the wishbone when
replacing the wheel bearing, disassembly of the drive shaft, renewing the shock absorber, etc.
SAFETY ADVICE
•
Check the tool for damage before use, do not use the tool if it is damaged.
•
Make sure that the tool is applied at a suitable place and does not slip when pushing down the
wishbone lever.
•
Always wear protective gloves when using the wishbone lever.
USE EXAMPLE
Loosen and remove clamping screws of the ball
joint bolt (A) or strut (B).
Position the hook (1) on the wishbone and the
support (2) on the front axle body.
Press the wishbone lever down.
Depending on which clamping screw has been
dismantled, either the ball joint separate from
the pivot bearing or the pivot bearing separate
from the strut.
A
B
1
1
2
