SW-Stahl und Werkzeugvertriebs GmbH
Tel. +49 (0) 2191 / 46438-0
F
5 6
e s s a r t S r e s u k r e v e L
ax +49 (0) 2191 / 46438-40
e d . l h a t s w s
@
o f n i : l i a
M - E
d i e h c s
m
e R 7 9 8 2 4 - D
Instruction Manual
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
BGS 7775
Hydraulic Drive Shaft Extractor
for Hole Circle Diameter 98 - 125 mm
TOOL PARTS
1
Threaded Reducing Ring,
1-1/2“ x 16-UN to 11/16“ x 10-UN
2
Adapter Foot, 1-1/2“ x 16-UN
3
Spindle, 11/16“ x 10-UN
4
Hydraulic Spindle,
1-1/2“ x 16-UN
INTENDED USE
This special tool kit is used for pressing out of glued and rusted drive shafts. It can be used for 4- and
5-hole wheel hubs with 98 to 125 mm hole circle and wheel bolts up to max. M14.
SAFETY INSTRUCTIONS
•
Do not use the tool kit if any part is damaged.
•
Wear protective gloves and goggles when using the tools. Wearing safety shoes is
recommended.
•
Observe the instructions of the vehicle manufacturer.
•
Use the product only for work specified under the purpose of use.
•
Improper use may result in damage to the tool or component and injury.
INSTRUCTION
1. Install the tool as shown in the photo on the right.
2. In the case of easily removable drive shafts, it is possible to
replace the hydraulic spindle by means of the spindle (3). To
do this, insert the reducer ring (1) into the adaptor foot (2)
and screw the spindle (3) into the reducer ring.
3. Position the tool centrally on the wheel hub and fasten it with
the original wheel bolts.
4. Turn the hydraulic spindle with the knurled part (A) clockwise
until the spindle rests on the drive shaft stub or cannot be
further turned by hand.
5. Turn the sliding bar (B) clockwise to press out the drive shaft.
6. Turn the sliding bar counter-clockwise, when the hydraulic
path of the spindle is not sufficient and repeat steps 4 & 5
until the drive shaft is pressing out completely.
