SW-Stahl und Werkzeugvertriebs GmbH
Tel. +49 (0) 2191 / 46438-0
F
5
6
e
s
s
a
r
t
S
r
e
s
u
k
r
e
v
e
L
ax +49 (0) 2191 / 46438-40
e
d
.
l
h
a
t
s
w
s
@
o
f
n
i
:
l
i
a
M
-
E
d
i
e
h
c
s
m
e
R
7
9
8
2
4
-
D
Instruction Manual
BGS technic KG
Bandwirkerstr. 3
42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
A.
Balancing wrench in hand with graduations visible with the marked arrow elementary Scale up
then unlock knurled handle by pulling sleeve.
B
Set amount of torque required by turning knurled handle to read exact amount on case
graduations.
EXAMPLE:
185 Nm
1.
Turn knurled handle until the zero graduation on the bevel edge of
the knurled handle is lined up with the vertical mark on the case
and is even with the 175 Nm graduation.
2.
Turn knurled handle clockwise until 10 Nm graduation on the level
edge of the handle is in line with the vertical line on the case.
Please note: When setting, the smallest possible division is 2.5
Nm.
3.
Lock handle securely by pushing sleeve, and now wrench is set at 185 Nm which is ready to use.
C
lnstall the proper socket to the square drive and apply to nut and pull handle until you feel and / or
hear wrench click. Release pull and wrench automatically resets for next operation.
Note:
Do not continue to pull after wrench releases. Use special care at low torque settings that will
pull stop when wrench clicks.
The wrench is only suitable for a permissible torque of max. 350 Nm.
Turn the torque wrench always back to the smallest value after using.
Do not use the torque wrench as long lever arm to loosen screws.
This is a precisions measuring instrument.
Calibration and servicing must be done regularly and is the owner responsibility.
