9
Locking the crimping tool
If the power is connected, the crimping tool must be locked before changing jaw sets.
To lock out the tool, hold the or button for 2 seconds. The display will show OFF and then flash
with the last jaw set code in use. The go-button will not start the tool when it is locked out.
Figure 2.
Press or button
for 2 seconds to lock
out the crimp tool.
Selecting or changing a jaw set while power is connected
First, lock the tool by holding the or button for 2 seconds.
Insert the jaw set into the bushing at the bottom of the tool. Push up against the spring load and then
twist until the set locks into position. (Figure 3)
To remove a jaw set push the lock button on the outside of the supporting cup and rotate. (Figure 4)
Figure 3.
Insert the jaw set into the
bushing at the bottom of
the tool. Push up against
the spring load and then
twist until the set locks
into position.
Figure 4.
To lock out the tool, press
the lock button and rotate.
