Gently ease the socket from the mounting box to show
the wiring.
4.
There will generally be three different wiring
configurations. This photo shows a single wire of each
colour connected to each terminal.
5.
Alternatively, there could be two or three wires of each
colour connected to each terminal.
6.
Place the blue wire(s) into the neutral terminal, brown
into the live terminal and green/yellow into the earth
terminal. The terminals on the socket are colour-coded
to help locate the correct one.
9.
Make sure that the wires are fully inserted into the terminal
and that no bare copper wire is visible. Tighten the screws
securely onto the copper wire, not the outer sheeting.
Before fixing remove screw covers from rear.
10.
Gently press the socket back into place over
the mounting box. Take care not to trap any wires
between the wall and the socket.
11.
Insert and tighten the retaining screws provided.
Use a spirit level to make sure that socket is level.
Restore the power at the consumer unit and test.
12.
After the initial power up the LED indicator will illuminate with a solid blue light. After
a short period of time the indicator will then start to blink and the product will then be
ready for set-up. Proceed with your preferred method of connection.
Screw Covers
Wireless setup information available on the next page.
