english
A 2 – Operation
17
The A 2 headphone amplifier can also be controlled via the
supplied remote control. The buttons allow the function described
below.
Note:
Direct the remote control at the infrared diode
of the amplifier.
To achieve a wide range, please make sure that the amplifier is
not exposed to direct sunlight.
On-off button
To turn on or off the A 2 which is connected to the mains.
Standby button
red: Device is in standby mode.
Standby button
green: Device is turned on.
Mute button
To mute the headphone.
Depending on the active input, the backlit button of the
A 2 for input 1
or input 2
will go out.
Mute can be deactivated by pressing the mute button once
again or by changing the volume with the volume control
of the remote control.
Selector button “Input 1”
Button to select the input 1 and to transmit the signal of the
device connected to input 1 on the A 2.
Orange backlit button “Input 1”
: Input 1 is active.
Selector button “Input 2”
Button to select the input 2 and to transmit the signal of the
device connected to input 2 on the A 2.
Orange backlit button “Input 2”
: Input 2 is active.
Volume control
Press “+” to increase the volume.
The volume control
on the A 2 will turn to the right and
the button for input 1 or input 2 on the A 2 will flash orange
as long as the volume control of the remote control is
pressed.
Press “-” to reduce the volume.
The volume control
on the A 2 will turn to the left and the
button for input 1 or input 2 on the A 2 will flash orange as
long as the volume control of the remote control is pressed.
Battery compartment
In order to insert/replace the battery (round cell Li-Mn,
CR 2032), please open the battery compartment. Use a
coin to turn the cover of the battery compartment 90° anti-
clockwise. In order to avoid scratches, wrap a soft cloth
around the coin.
6.
Remote Control
Front View
Rear View
Summary of Contents for A 2
Page 1: ...A 2 KOPFHÖRERVERSTÄRKER HEADPHONE AMPLIFIER Bedienungsanleitung Operating Instructions ...
Page 22: ......
Page 23: ......