BEX K730 Quick Manual Download Page 2

 

2

INSTRUCTIONS FOR USAGE AND MAINTENANCE OF CRIMPING HANDTOOL K730 

 
To obtain best crimping results, trouble-free function and long lifetime of the tool, please follow further instructions for 
usage and maintenance. 

Terminating procedure 

After cable and microplug have been prepared, open handtool and 
insert microplug assembly into the opening of the die set (as shown 
on Fig.1.) until plugs´ locking tab (A) snaps into place. Check if 
microplug is properly positioned in the die set and slowly close the 
tool completely until ratchet mechanism is released. Press locking tab 
(A) on the microplug and remove crimped connection from the die set. 

 

Fig.1. 

Unblocking the tool 

 
Should the handtool become blocked during the work due to faulty crimp or because of presence of an foreign object 
in the tools’ mechanism, the obstruction must be removed before the work with the tool is resumed by performing 
following actions: 

 

IMPORTANT: Apply working force on the tool 
handles while unblocking. It will prevent hurting 
yourself and possible damages of the tool. 

Using small screwdriver or similar tool, push the 
ratchet relief (A),  located inside moving handle, ( Fig. 
2.) in direction as shown to unblock the tool, and 
remove obstruction before continuing with the work. 

 

With this tool 

only

 microplugs of 

appropriate type

 

have to be used. Crimping microplugs of unsuitable 
type may result with unsatisfactory characteristics of 
crimped connections and eventually with damaging of 
the tools and is to be strictly avoided.  

 

Fig. 2. 

 

Although tools’ lever system allows user to exert very high forces, forcing the tool by any means into closed position 
by applying very large force onto handles is to be 

strictly avoided

 as it may cause irreparable damage to crimping 

dies and/or to handtool itself.  

Tool regulation procedure

 

After prolonged work period, tool crimping performance can change slightly due to final self-adjustment of the tools’ 
components. That is why handtool is equipped with eccentric axle which allows periodical adjustment of the crimping 
force and tool recalibration to maintain correct crimp performance. 

1.  Loosen and remove allen head screw (A) using a 2.5 

mm allen wrench. (Fig.3.) 

2.  Using a screw driver turn eccentric axle (B) and 

toothed adjustment wheel (C) into new position. 

dir  for enlarging crimping force and 

reducing gap between crimping dies 

direction –  for reducing crimping force and 

enlarging gap between crimping dies 

3.  Reinstall allen head screw (A) and tighten it.  

Fig. 3. 

General remarks

 

  Crimping handtool K730 with corresponding die sets is intended for crimping of modular microplugs. Using this 

handtool for any other purpose or for crimping any other elements can result in damaging the tool and the elements 
being crimped and prevention of its normal further functioning for what manufacturer cannot be held responsible. 

  For removal of dust, moisture and other contaminants usage of clean brush or soft, lint-free cloth is recommended. Do 

not use agressive agents (thinner, alcohol,...) or hard objects that could damage the tool. 

  Make sure that during the work bearing surfaces, shafts and pivot points are protected with thin coat of quality 

machine or motor oil. Do 

not

 oil excessively. 

  When the tool is not in use, store it in a closed position – with handles closed. That will keep other objects from 

becoming stuck between crimping dies and damaging them. Keep the tool in dry, clean area. 

 

Reviews: