16
Bewacom Technical manual
Changing entrance codes
1
Set Bewacom to programming mode.
2
Enter the access code to change.
3
Enter the new access code.
4
Enter the new access code again.
5
To only change the code – without
changing the time control group – press
B now.
If the code is not timed, press
0
.
If the is timed, select the desired
input (see below).
1
= the code can be timed from a
time clock connected to input 1.
2
= the code can be timed from a
time clock connected to input 2.
Also see the wiring diagram on
page 10.
6
Follow steps 2-5 to change the next code.
7
Press B to exit programming.
