PAGE 10
Add: Floor3,Building A,No.257,Junye Road,Huangpu District,Guangzhou,China
E-mail:[email protected] Http://www.bevsinfo.com
3.4.3 All the settings must be saved before being effective, if return to last menu directly without
saving, then all the settings will be ineffective.
4 Maintenance
1 Before carrying out any maintenance, ensure machine is disconnected from mains supply
2 At least one time clean for the component on the trough frame every week
3 At least one time check for the friction head connecting every month, ensure the correct
installation of friction head and run in free movement
4 Check the pump condition every month
5 Once a year, disconnect from mains. Tilt machine on its back, remove base, and undo screws
located in each corner. Clean two slide rods and regress using Lithium grease. Replace base and lay
machine on a level surface.
5 Attention
5.1 Make sure that the machine is used in a dry, non-corrosive environment
5.2 Putting on the firm working surface
5.3 There must have the reliable ground wire in the outlet
5.4 Operation Condition: Using this machine in the room with the temperature in between 15 to 35
degrees
6 Order Information of Accessories
BEVS 2805/1/P---Accessory DIN53778 Applied weight 250g, 2 brushes with natural bristle
BEVS 2805/1/P---Accessory ASTM D2486 Applied weight 454g, 2 nylon brushers, 2 rubber pads
with 325*12.7*0.25mm brass shim
BEVS 2805/1/P---Accessory ASTM D3450 Applied weight 750g, 2 sponges
