14
•
Plug the other end of the mains part into a suitable socket.
Fully charge the battery prior to initial use (ap-
prox. 2 hours). During charging, the "CHG" display on the daylight therapy lamp lights up green. When the
battery is fully charged, the "CHG" display goes out.
•
If you would like to use the daylight therapy lamp after charging,
first of all disconnect the mains part
from the socket, and then from the daylight therapy lamp.
• With the battery completely charged, you can operate the daylight therapy lamp for over 2 x 30 minutes.
Note:
• Ensure that there is a mains socket close to the set-up area.
• Arrange the mains cable so that no-one will trip over it.
6. Operation
1
Remove the stand from the storage slot on the rear of the device.
2
Clip the short end of the stand into the side. The orientation of the TL55 changes depending on where
you attach the stand to the device. The stand can be attached on both the long and short sides, which
enables you to use the TL55 both horizontally and vertically.
3
Switching on the lamp
X
To switch on the red light (light to fall asleep), press the ON/OFF button once.
X
Press the ON/OFF button twice to switch on the brightlight.
Note:
The daylight therapy lamp has an automatic switch-off function. The brightlight/red light switches
off automatically after 30 minutes. During the 30 minutes, the red light automatically dims. In con-
trast, the brightlight illuminates to the same level of brightness for the 30 minutes.
All manuals and user guides at all-guides.com