Beurer HK 72, Instructions For Use Manual, Page: 5 / 24

5
Checking Battery Pack charge level:
1. Ensure the heat wrap is not connected to the Battery Pack.
2. Press the Power/Control Button.
If the Battery Level LED illuminates for at least three seconds, the Battery Pack is at least 25% charged.
If the Battery Level LED flashes three times, the Battery Pack is less than 25% charged.
4. To Use
1
2
3
4
1
1
2
3
4
1. Insert the charged Battery Pack into the Battery Pouch in the heat wrap with the LED Display show-
ing through the mesh panel. Attach the Heat wrap Connector Plug to the Power Socket on the Battery
Pack.
2. Place the heat wrap on your stomach or on your back with the brown mesh panel facing away from
your body. Place the right strap of the heat wrap around your waist and secure the heat wrap by clos-
ing the hook-and-loop fastener.
CAUTION: Ensure that the heat wrap does not bunch up or fold over during
use.
3. Press the Power/Control Button; the blue LED for temperature setting "1" illuminates. Press the Power/
Control Button again to increase the temperature setting; repeat until the desired temperature setting
is reached. The corresponding Temperature Setting LED will illuminate. Temperature Setting "1" is the
lowest and "4" is the highest/hottest.
4. To shut off the heat wrap, continue pressing the Power/Control Button until all LEDs shut off.
WARNING
If the heat wrap is being used over several hours, set the lowest temperature setting on the Battery
Pack to avoid overheating the heated body part, which may lead to burns to the skin.
NOTICE
Protect the Battery Pack from extreme cold to maintain its performance.
NOTICE This heat wrap has a fast heating function, which allows the heat wrap to warm up quickly in
the first 10 minutes.
When the Battery Pack level is low, the heat wrap will shut off. The Battery Pack must then be charged
before using it again.
Automatic shut-off:
This heat wrap is equipped with an automatic shut-off function that shuts the heat wrap off after about
90 minutes. Press the Power/Control Button to switch the heat wrap back on. If the heat wrap does not
switch on, the Battery Pack is depleted and must be recharged.
5. Cleaning and Maintenance
WARNING
Prior to cleaning, always disconnect the Battery Pack from the heat wrap and remove it from the heat
wrap pouch, otherwise there is a risk of damage.
The Battery Pack must never come into contact with water or other liquids, as this may cause damage.
To clean the Battery Pack, use a dry, lint-free cloth. Do not use any chemical or abrasive cleaning agents.