16
6. The hour flashes on the LCD Display. Set the hour
with the
+/-
Buttons and press the
SET
Button to
confirm.
7. The minutes flash on the LCD Display. Set the min-
utes with the
+/-
Buttons and press the
SET
But-
ton to confirm.
8. ’On’ will flash in the LCD Display. Use the
+/-
But-
tons to select whether to activate (’On’) or deacti-
vate (’Of’) automatic
Bluetooth
®
data transfer to a
mobile device. Press the SET Button to confirm and
exit. Note that keeping
Bluetooth
®
activated will in-
crease battery drain.
7. Measuring Blood Pressure
The blood pressure monitor needs to be at room
temperature when measuring. Measurements can
be performed on either arm.
Positioning the Cuff:
Place the cuff on to the bare left
upper arm. The circulation of
the arm must not be hindered
by tight clothing or similar.
The cuff must be placed on
the upper arm so that the
bottom edge is positioned
0.8 - 1.2 in (2-3 cm) above
the elbow and over the artery.
The line should point
to the centre of the palm.
Now tighten the free end of
the cuff, but make sure that it
is not too tight around the
arm and close the
hook-and-loop fastener. The
cuff should be fastened so that
two fingers fit under the cuff.
Now insert the cuff line into
the connection for the cuff
connector.
Blood pressure can vary between the right and left
arm, which may mean that the measured blood pres-
sure values are different. Always perform the meas-
urement on the same arm.
