Better Music Builder DX-3000 G2, Owner'S Manual

Page: 7 / 29

7
1
SHIELD
COLD
HOT
2
3
1
2
3
SHIELD
COLD
HOT
2
1
3
SHIELD
COLD
HOT
MALE
FEMALE
Balanced XLR Connectors
XLR TRS
Hot (+) Pin 2 Tip
Cold (-) Pin 3 Ring
Shield (Ground) Pin 1 Shield
RING (COLD)
TIP (HOT)
SLEEVE (SHIELD)
SLEEVE RING RING SLEEVE TIP
TIP
Balanced 1/4” TRS Plug
RING (COLD)
TIP (HOT)
SLEEVE (SHIELD)
SLEEVE SLEEVE TIP
TIP
Unbalanced 1/4” TRS Plug
RCA Unbalanced Jack
SLEEVE
SLEEVE
TIP
TIP
SLEEVE
SLEEVE
TIP
TIP
R (right)
L (left)
CONNECTOR INFORMATION
Either banana plug or insert type can be used to connect the
unit to speakers. Be sure to connect red (+) to red (+) and
black (–) to black (–). Otherwise, the sound output would be
180° out of phase and distorted.
Follow these steps if you are inserting the wire directly into
the speaker terminal.
1. Strip off the vinyl covering and twist the tip of the
wire core.
2. Loosen the knob and insert the wire core into the
terminal hole.
3. Tighten the knob to fix the wire core in place.
Do not allow the wire core to protrude or touch other
terminals or wires.
If the cores of differing wires touch, damage may result to
your components.
METHODS OF SPEAKER CONNECTION
1. Insert Type (Poor Connection)
2. Single Banana Plug Type
(Better Connection)
SPEAK
ERS
SPEAK
ERS
NO GOOD GOOD
3. Double Banana Plug Type (Standard Connection)
SPEAK
ERS
3/4”
19 mm
SPEAKER CONNECTION METHODS AND INFORMATION
Connection