31
3 prong to 2 prong adaptor
110V~120V
FIGURE 1
Qualit y Power Cord:
105°C 3C/18AWG 30 0V
FIGURE 2
NOTE
SPEAKERS
A_KOD
"A_"stands for auto mode
M_KOD
"M_"stands for manual mode
10. INPUT SIGNAL AUTO JUMP
SYMPTOM:
When selected VOD or KOD input source, the
system automatically select back to the DVD input terminal.
CAUSE:
Because this model is design for priority input select.
REMEDY:
When set on auto mode, the priority source is DVD
by default. Therefore, if multiple source is use simultaneously, it
will auto jump to the priority source. Adjusting to manual mode
will turn off the auto priority mode.
11. BASS ON VOCAL SOUND IS NOT CLEAR
When you sing or make an announcement with the
microphone, there is too much bass. You may be connecting
to the subwoofer improperly. It is because the SUB OUT of this
unit has two different functions: Bass is only for music and not
for vocal.
12. BAD AUDIO OR MICROPHONE SOUNDS
REMEDY:
Check the source of your audio (CD, DVD) to see if it’s scratched.
Check your audio cables or microphone cables.
Use a better audio cable or 3pin XLR mic cable.
13. THERE IS NO PICTURE
REMEDY:
Check to see if your video sources are selected accordingly.
Check to see if you plugged in the video cables.
Check your TV or display monitor.
14. VIDEO IS FLICKERING
REMEDY:
Check to see if the AV cable is damaged.
Use a better AV cable.
We recommend you to connect videos to the TV or monitor
directly for best results.
15. VIDEO SIGNAL OUT RECOMMENDATIONS
REMEDY:
If you have more than 2 RCA output to the display,
we recommend you use a signal amplifier. The signal amplifier
will stabilize your video quality. If you have a HDTV (Plasma,
or LCD) video we recommend you directly connect your source
to the video display.
16. POWER CAN NOT BE TURNED ON
REMEDY:
Check to see if your unit is plugged in properly.
Check your power cable.
17. PROTECTION FOR AUDIO/VIDEO EQUIPMENT
Before you hook up or disconnect any audio/video equip-
ment, you must turn off the power for all equipment. Otherwise,
it may cause black spots to appear on the LCD or Plasma TV
screen.
18. AUDIO FEEDBACK
REMEDY:
• Turn down the dB on the equalizer especially 1K, 2.5K, 5K,
and 10K Hz.
• Turn off the Mix Excite.
19. AMPLIFIER SHUT DOWN/INTERFERENCE NOISE
CAUSE:
The amplifier turned on but there is no music coming
out from the speaker powered output channels.
REMEDY:
Make sure that the AC-power supply is connected to
the correct voltage level according to the local market.
20. NOISE AND DISTORTION
When humming noise or displeasing sound appears, you can
replace the supplied power cord with an AC power cord with
a magnetic device as shown in the figure below.
In North America many families own satellite TVs, HD TVs and
cable TV receivers. They may cause interference which affect
both audio and video equipment. The power cord as shown in
figure 2 may help eliminate the humming sound and enhance
TV picture quality.
21. SOUND PROBLEM:
No sound.
REMEDY:
Positive and negative of
speaker wire are touching
each other at the terminals.
We recommend using
double banana plugs.
