INSTALLATION GUIDE
VERI SHADE
Please Note: These instructions should be read thoroughly before installing.
This is a guide to assist in the installation and care of your blinds. Betta Blinds and Awnings does not guarantee the accuracy of
the information contained in this guide. We recommend an experienced expert installer to rely upon their own skills. This is
based on general knowledge concerning the assembly, materials and working process of the blinds, which is known to us at the
time of printing this guide, consequently, is subject to change and Betta Blinds & Awnings specifically reserves the right to
change this guide without notification.
We recommend the use of the following Tools:
Steel measuring tape, Carpenter’s level, Power or battery drill & bits, Flat blade, Phillips head screwdrivers,
Needed if blade creasing has occurred -
Iron and Small Ironing Board
The following should be included for each Veri Shade blind ordered.
Mounting clips (number depends on size)
Mounting brackets (if face fixed)
Wand (standard)
We recommend clean, soft cotton gloves
(or the rubber gloves supplied)
be worn to avoid marking the fabrics when
installing and handling fabric blinds.
Since different screws are required to suit different fixing applications, we do not supply screws. Please ensure you use the correct screws
for mounting to the desired application, for example Gyprock, timber, concrete, brick, steel, or aluminium.
The most important procedure in installing these blinds is to be sure that the correct anchorage method has been used so that
the mounting area (i.e., wall or architrave) is able to support the weight of the blind and its operation
.
Brick or Rendered Surfaces Warning:
Make sure drilling is no closer than 25mm from edge of surfaces as the brick or
render may chip or break out.
TRACK INSTALLATION
Face & Reveal
1. After receiving the order check the marked width and drop sizes as indicated on the blind against your original order. To
assist you in establishing the correct location for fitting multiple blinds the room location is marked on each blind, as per your
order.
2. If all is correct layout the blinds at their location and remove protective packaging.
3. Remove the supplied installation brackets from packaging.
4. Ensure the blind has brackets to suit the application, either face fix or reveal.
5. Remove the supplied installation brackets and wand off the top of the track.
FOR REVEAL FIT
- Install blind into recess as far as possible. Allow sufficient clearance for blades to rotate.
BLADE WIDTH SCREW POSITION
200mm blades will be 85mm
FOR FACE FIT
- Mark where you are attaching the brackets on the architrave/wall of the window
6. Evenly space and screw the brackets along the front of the architrave or wall/window (depending on face or reveal fit) for
even load bearing distribution. The end brackets should be mounted no further than 200mm from the end of the blind
7. Level mounting of brackets is critical for the correct operation of the blind (use a spirit level).
8. Betta Blinds supplies mounting brackets only and where appropriate the child safety devices.
9. Once the brackets have been installed and levels checked the track is ready to be installed into the brackets
10.
CUBE TRACK:
Install the track by placing the front section of the track into the allocated and matching clip end, lift the rear
section of the track into the bracket until it locks in. If correctly installed it will click when locked firmly in place. Working from
one side to the other. Check that each clip is secure in place before moving to the next.
11.
DECORATIVE TRACK:
Install the track by lining the track keyway with the bracket spin clip. Once in line turn spin clip until
the track locks in place with the brackets. Working from one side to the other. Check that each clip is secure in place before
moving to the next.
