Step 2: Insert the Bottom Section into the Tree Stand
A.
Remove plastic cap at the end of the metal pole.
B.
Locate the notch in the tree stand (use arrow stickers as a guide).
C.
Locate the open groove in the bottom section (the bottom section is marked with “A”). Use arrow stickers as
a guide.
D.
Insert the bottom tree section (bottom section is marked with “A”) into the stand making sure that the
groove slides into the notch. Arrows will be pointing to each other. The lights will turn on once it drops into
the correct placement.
E.
If the lights do not turn on, refer to the Trouble Shooting portion of this document. Do not drive the section
down with force or forcefully turn the section. Doing so may damage the plugs.
F.
Let the hinged branches fall into place.
G.
Adjust the branch tips for desired appearance (some people chose to perform this step when the tree is fully
assembled).
H.
Tighten screws in stand to secure the tree.
Step 3: Insert the Middle Lower Tree Section into the Bottom Tree Section
A.
Remove plastic cap at the end of the metal pole.
B.
Locate the notch, groove, and arrows as described above.
C.
Insert the middle lower section into the bottom section (middle lower section is marked with “B”). Line up
the arrows as described above. The lights will turn on once it drops into the correct placement.
D.
Adjust the branch tips for desired appearance (some people chose to perform this step when the tree is fully
assembled)
Indoor Use Only
Made in China
H201126INST042013
2
