BETCO PB21-11, Operator'S Manual

Page: 9 / 23

BEFORE STARTING THE MACHINE
Before the machine is operated, you first should read your Engine Operation Manual and your
Owner’s Manual.
x Your machine is shipped ready operation; however there is no fuel in the tank. When having
the tank filled, you must make sure the tank is never over filled.
o
The best way to do this is to tell the filling station to weigh the tank full. On an aluminum
tank, it should weigh no more than 36 pounds and on a steel tank no more than 43
pounds. (See more information at “Tank Storage and Maintenance” page.)
x Adjust the handle for comfortable operation. Remove hairpin cotter pins from clevis pins,
remove pins, and adjust to the hole alignment that gives the most comfortable height.
Replace clevis pins and hairpin cotter pins. Tighten nuts and bolts if needed.
x Make sure pad is not torn, pad is well attached and centering device is tightened.
x Check Oil Level: Starting the engine without the proper amount of oil will cause severe
engine damage. Always keep the engine oil level between the full and add marks on the
dipstick. Do not loosen oil fill cap or remove dipstick while engine is running.
o
Park your burnisher on a level surface.
o
Turn the oil fill cap counter clockwise and then lift from the fill tube.
o
Wipe the dip stick clean and push it back into the oil fill tube until the cap seats and then
withdraw it to check: the oil level. (Do not screw cap on to check oil). Add if necessary. If
the oil level is low, add API Class SM oil having a SAE viscosity grade appropriate for
the expected temperatures as indicated in the Operators Manual (Usually a HD30 or
10W30).
o Important Note: DO NOT OVERFILL
o
Replace oil cap.
x
Inspect fuel hoses and fittings for wear and leaks. Have all worn hoses and leaks repaired
before operating..
x
Look and listen for exhaust leaks. Have all leaks repaired before operating.
x
Check the carburetor filter and air filter for debris. Clean and replace if necessary.
x Connect fuel hose to tank by screwing the hose fitting to tank. You must tighten all the way
down to make fuel connection. Turn tank knob slowly until you hear the flow of fuel into fuel
system.
BETCO, CORP. 7/26/07 Page 9 PROPANE BURNISHER