9
PREPARING THE MACHINE
4.
CONNECTOR CONNECTON
6.
Connect the battery connector to the machine connector
7.
Re-assemble everything
ATTENTION
: This procedure must be done by qualified personnel.
Mistaken or imperfect connection of cables to the connector can cause
severe damage to persons and property.
5.
RECHARGING THE BATTERIES
Carry out a battery charge cycle before using the machine.
In case of battery's replacing, verify to use proper batteries for the type of battery charger installed
(use only batteries 12V AGM or Gel).
After switch off the machine, insert the thorn of the battery charger into the plug.
Follow the instructions in the attached booklet in order to properly use the battery charger.
ATTENTION:
The machine is predisposed with an automatic system that
removes the tension from the electric plant when it's in phase of recharge
the batteries.
ATTENTION:
Avoid totally discharging the batteries: this can cause damage
to them. Recharge within just a few minutes after the battery discharged
signal lamp starts to flash.
ATTENTION:
Never leave the batteries completely discharged, not even if
the machine is not being used.
ATTENTION:
Carefully keep to the instructions provided by the
manufacturer or its retailer when performing daily battery recharge. All
installation and maintenance procedures must be done by expert
personnel. Danger of gas fumes and leakage of corrosive fluids. Danger of
fire: do not approach with open flames.
6.
BATTERY CHARGE LEVEL GAUGE
The battery charge level gauge is a digital unit with 4 fixed and one flashing position. The numbers
on the display give an approximate idea of the level of charge.
4
= maximum charge,
3
= charge 3/4,
2
= charge 2/4,
1
= charge 1/4,
0
= batteries discharged
(flashing)
ATTENTION
: The brush motor automatically turns off a few seconds after
the flashing “0” appears. The remaining charge permits to finish drying
before carrying our recharge.
