12
MACHINE PREPARATION
13. ASSEMBLY CYLINDRICAL BRUSHES
1.
Brake the machine acting upon the lever (1)
2.
Lift the brush base acting upon the lever (2)
3.
Turn the key (1) into position “0” and take it of
4.
Remove the lateral right splash guard (see DISASSEMBLY AND CLEANING OF THE BRUSH
UNIT)
ATTENTION!
Use gloves for this operation in order to protect your hands
1.
Insert the brush in the tunnel (Side with 5 teeth) until it is coupled with the traction hub
2.
Insert the free hub (1) of the mobile support into the brush (side with 6 teeth)
3.
Repeat the operation for the second brush
4.
Assemble the lateral splash guards (2)
1
2
14. RECOVERY TANK
Open hood (1).
Check:
1.
that plug (2) is properly anchored (it must not pull out when it is lifted, otherwise turn it
clockwise);
2.
that aspiration tube (3) is inserted in its seat.
15. SOLUTION TANK
Fill the solution tank with clean water at a temperature not in excess of 50°C. Add liquid detergent in
the amounts and using the procedures recommended by the detergent manufacturer. Use only a
minimal percentage of detergent to prevent formation of an excess quantity of foam since too much
foam may damage the aspiration motor.
ATTENTION!
Always use low-foam detergent. Introduce a small amount of
anti-foam detergent in the recovery tank before starting to work to be sure to
prevent foam from being generated.
Never use pure acids.
