BETCO E27200, Operator And Parts Manual

Page: 50 / 52

50
TROUBLESHOOTING GUIDE
ISSUE POTENTIAL CAUSE PROPOSED SOLUTION MANUAL SECTION
INSUFFICIENT WATER TO SCRUB HEAD SOLUTION SETTING TOO LOW ADJUST SOLUTION CONTROL SOLUTION DISTRIBUTION
SOLUTION TANK IS EMPTY ADD WATER TO THE SOLUTION TANK SOLUTION DISTRIBUTION
SOLUTION TUBE IS KINKED OR CLOGGED INSPECT TUBES SOLUTION DISTRIBUTION
SOLUTION SHUTOFF VALVE IS CLOSED OPEN VALVE SOLUTION DISTRIBUTION
SOLUTION PUMP IS NOT FUNCTIONING VERIFY OPERATION AND/OR REPLACE PUMP
PARTS DIAGRAM
STRAINER SCREEN IS CLOGGED
CLEAN OUT STRAINER BOWL AND SCREEN PARTS DIAGRAM
POOR WATER RECOVERY RECOVER TANK IS FULL EMPTY RECOVERY TANK RECOVERY SYSTEM
DIRTY OR WORN SQUEEGEE BLADES INSPECT/ROTATE/REPLACE AS REQUIRED RECOVERY SYSTEM
RECOVERY HOSE LOOSE OR KINKED INSPECT/REPAIR/REPLACE
RECOVERY SYSTEM
RECOVERY HOSE OR SQUEEGEE IS OBSTRUCTED CLEAR OBSTRUCTION FOR SYSTEM
RECOVERY SYSTEM
SQUEEGEE ASSEMBLY MAY BE OUT OF ADJUSTMENT ADJUST AS NECESSARY RECOVERY SYSTEM
STUCK OR DAMAGED BALL FLOAT INSPECT/REPAIR OR REPLACE RECOVERY SYSTEM
RECOVERY TANK LID IS NOT SEALING PROPERLY INSPECT SEAL AND REPLACE IF DAMAGED PARTS DIAGRAM
DRAIN HOSE CAP IS NOT INSTALLED PROPERLY INSTALL DRAIN HOSE SECURELY RECOVERY SYSTEM
CLOGGED HEPA FILTER REMOVE AND INSPECT INSIDE AND OUTSIDE OF HEPA FILTER.
REPLACE IF DAMAGED.
PARTS DIAGRAM
LOW BATTERY VOLTAGE CHARGER BATTERIES CHARGING
MACHINE WILL NOT TURN ON FAULTY KEY SWITCH DIAGNOSE AND REPLACE WIRING DIAGRAM
DISCHARGED BATTERIES CHARGE BATTERIES CHARGING
LOOSE OR DAMAGED WIRE/CONNECTION ADJUST THE MIXTURE AS REQUIRED SOLUTION DISTRIBUTION
MACHINE IS NOT CLEANING PROPERLY WORN PAD OR BRUSH
INSPECT AND REPLACE AS REQUIRED SCRUB DECK SETUP
WRONG PAD PR BRUSH FOR APPLICATION
CONTACT YOUR LOCAL DISTRIBUTOR FOR RECOMMENDED
APPLICATION
SCRUB DECK SETUP
INSUFFICIENT CLEANING SOLUTION FOR APPLICATION ADJUST THE MIXTURE AS REQUIRED SOLUTION DISTRIBUTION
VACUUM MOTOR WILL NOT SHUT OFF STILL IN DELAY MODE ALLOW 7 SECONDS TO SHUT DOWN RECOVERY SYSTEM
VACUUM RELAY MAT BE FAULTY CONTACT SERVICE TECHNICIAN TO TROUBLESHOOT AND
ISOLATE
WIRING DIAGRAM
SCRUB HEAD WILL NOT RUN SCRUB HEAD WILL NOT RAISE
LOWER SCRUB HEAD SCRUB DECK SETUP
BATTERY PROTECTION IS INDICATING LOW WATER SERVICE THE BATTERIES BATTERIES
BATTERIES ARE LOWER THAN ALLOWABLE CHARGE BATTERIES CHARGING
CIRCUIT BREAKER FOR THE BRUSH MOTORS IS TRIPPED SEE THE NEXT SECTION TITLED "SCRUB HEAD CIRCUIT BREAKERS"
TROUBLING SHOOTING TABLE
BAIL SWITCH IN HANDLE MAY BE FAULTY
INSPECT AND REPLACE AS REQUIRED
PARTS DIAGRAM
BATTERY RELAY MAY BE FAULTY CONTACT SERVICE TECHNICIAN TO TROUBLESHOOT AND ISOLATE WIRING DIAGRAM
SCRUB HEAD CIRCUIT BREAKER IS TRIPPED INADEQUATE SOLUTION FOR APPLICATION INCREASE SOLUTION TO SCRUB HEAD PRE-USE SETUP
SCRUB HEAD IS SET ON HEAVY DOWN PRESSURE
REDUCE DOWN PRESSURE SETTING PRE-USE SETUP
PAD IS TOO AGGRESSIVE FOR APPLICATION
CONTACT YOU LOCAL DISTRIBUTOR FOR RECOMMENDED
APPLICATION
PRE-USE SETUP
FAULTY OR SHORTED WIRE REPAIR WIRING DIAGRAM
WEAK CIRCUIT BREAKER
CONTACT SERVICE TECHNICIAN TO TROUBLESHOOT AND
ISOLATE. THE CIRCUIT BREAKER SHOULD NOT TRIP BELOW
IT'S STATED RATING.
PARTS DIAGRAM
MACHINE WILL NOT DRIVE CIRCUIT BREAKER MAY BE TRIPPED
INSPECT ANDRESET. IF PROBLEM PERSISTS CONTACT YOUR
SERVICE TECHNICIAN
PRE-USE SETUP
BATTERY METER IS FLASHING A FAULT CODE REFERENCE FAULT CODE AND TROUBLESHOOT AS REQUIRED PRE-USE SETUP
BATTERIES DISCHARGED TOO LOW
CHARGE THE BATTERIES CHARGING
SPEED KNOB TURNED ALL THE WAY DOWN
INCREASE SPEED SETTING DRIVE SYSTEM
FAULTY CONTROLLER CONTACT SERVICE TECHNICIAN TO TROUBLESHOOT AND
ISOLATE
WIRING DIAGRAM
FAULTY WIRING
CONTACT SERVICE TECHNICIAN TO TROUBLESHOOT AND
ISOLATE
WIRING DIAGRAM
RUN TIME IS SHORT BATTERIES ARE LOW ON WATER(LEAD ACID ONLY) SERVICE BATTERIES BATTERIES
CHARGER IS NOT PROPERLY SET FOR BATTERIES
SET CHARGER TO BATTERY SPECIFICATIONS CHARGING
SCRUB HEAD IS IN HIGH DOWN PRESSURE
REDUCE SCRUB HEAD PRESSURE PRE-USE SETUP
BATTERY CHARGER IS NOT ABLE TO FINISH CHARGE CYCLE CONFIRM A STEADY GREEN LIGHT AFTER THE CHARGE
CYCLE(BEFORE UNPLUGGING FROM THE OUTLET)
BATTERIES