2
General Instructions for the CREWMAN
™
DC2000
Operating Instructions
Check machine for damage to cord or plug.
Use only Hi Speed Burnishing pads 20” or 19” diameter.
To install or change the pad:
1. Unplug the machine.
2. Tip the machine back on the wheels.
3. Remove the center-lock.
4. Center the pad on the pad driver.
5. Replace the center-lock and tighten securely.
To operate the machine:
1. Plug into a grounded outlet.
2. Release the handle and lower it.
3. The handle can be locked into a comfortable position
for the operator or used free fl oating.
4. Press the safety lever and squeeze the trigger to start
the
machine.
5. Do not operate in one place as damage to the fl oor or
fi nish could result.
6. The machine should be operated in the green area
of the meter on the handle. Turn the knob on the
back to increase or decrease the pad pressure.
7. Do not operate the machine with the handle in the
upright
position.
8. Remove the pad after every use.
9. Use only new or clean pads and reverse them
as
needed.
Maintenance
To maintain appearance - wipe the machine with a damp cloth
after use.
Warning
- Unplug the machine before servicing
The operator should check the following at 250 hour intervals:
1. Check the motor brushes for wear or
excessive
arcing.
2. Check the cord and electrical system.
3. Check the safety lockout on the trigger.
4. Check wheels and bearings.
5. Check the Dust shroud and brush seal.
6. Check the Dust bag before each use.
Specifi cations:
Length - 30 in.
Width - 22 in.
Height - 50 in.
Weight - 69 Lbs.
Pad Speed - 2000 RPM
Pad Diameter - 20 in.
Drive motor - 1.5 HP, 120v, 15 A, 50/60 HZ
Cord - 14-3 ST, 75 ft.
Safety
Read and understand the manual before operating
this machine.
• Do not operate in explosive areas or use near
fl ammable liquids or gases.
• Attach only to properly grounded outlet.
• Do not expose to rain, store indoors.
• Do not operate the machine with a damaged
cord
or
plug.
• Do not block or disconnect the safety lever.
• Do not leave the machine plugged in
while
unattended.
• Unplug the machine before servicing.
• Do not put fi ngers under the pad or pad holder.
• Unplug the machine before installing or
removing
the
pad.
• Use only with Hi Speed Burnishing pads.
10 Year Coverage
Subject to the conditions stated below, Betco warrants parts and labor on ro-
tationally molded polyethylene tanks/housings and injection molded vacuum
head assemblies to be free from defects in materials and workmanship for a
period of ten years to the original purchaser.
3 Year Coverage
Subject to the conditions stated below, Betco warrants parts and labor on all
other Betco components to be free from defects in materials and workman-
ship for a period of three years to the original purchaser.
1 Year Coverage
Subject to the conditions stated below, Betco offers a limited warranty on
parts and labor on the following equipment: parts and accessories to be free
from defects in materials and workmanship for a period of one year to the
original purchaser. DM Series Vacuums: #85506-00, #85507-00 Bac Pac Lite
Vacuum: #85903-00 FiberPRO
®
Floor Dryer: #85507-00 WORKMAN
™
Series
Vacuums: #85024-00, #85025-00, #85026-00, #85027-00 CV100T Vacuum:
#85023-00. All Tools and Accessories/All Battery Chargers/All Batteries are
pro-rated for 1 year.
Allowable Travel Time Warranty Reimbursement:
Eligible equipment: All battery and propane powered equipment products.
Warranty period: 90 days from date of sale to the original purchaser. A maxi-
mum 180 mile round trip at 50 cents per mile will be allowed for warranty
consideration.
Propane Machine Warranty:
Kawasaki engines are warranted by Kawasaki for a period of 2 years against
manufacturer defects. All other components (except wear items)* are war-
ranted by Betco for a period of 3 years.
*Wear Items exempt from Warranty consideration include but may not be
limited to: power cords, transport wheels, vacuum bags, belts, squeegee
blades, pad drivers, clutch plates, handle grips, fi lters, screens, throttle
cables, brushes and carbon brushes.
Subject to the conditions and exceptions stated in this warranty, Betco war-
rants the Betco products to be free from defects in material and workman-
ship, under normal use and service, for the periods listed under the warranty
policy to the original purchaser. At any time during the warranty period, Betco
will furnish replacement parts for the Betco parts to the original purchaser.
Such parts will be furnished and charged including transportation costs, to
the original owner through any Betco authorized Service Distributor. If the
original part is returned within the warranty policy period from date of de-
livery for inspection by Betco and is found to be defective the owner will
be credited for the cost of replacement parts plus shipping and handling.
Replacement parts that have become defective through wear or abuse are
not included in this warranty. This warranty does not apply to damage or
defect caused by accident, misuse. Negligence, fi re, or to any Betco product
which has been serviced or repaired by other than an authorized Betco Ser-
vice Distributor or Betco factory personnel. This warranty is void if products
are used for any purpose other than that which was intended. There are no
other warranties expressed or implied. In no event shall Betco be liable for
incidental or consequential damages or any damage to person or property.
(Please note some states do not allow the exclusion or limitations for inci-
dental and consequential damages).
BETCO US WARRANTY POLICY
