WARNING
IMPORTANT SAFETY
INSTRUCTIONS
When installing and using this electrical equipment, basic safety precautions should
always be followed, including the following:
READ AND FOLLOW ALL
INSTRUCTIONS
WARNING
- RISK OF ELECTRIC SHOCK -
The pump cannot be using while
people are inside the pool.
WARNING
- TO REDUCE THE RISK OF INJURY,
do not permit children to
use this product unless they are closely supervised at all times.
WARNING
- RISK OF ELECTRIC SHOCK.
Connect only to a grounding type
receptacle.This product is provided with a ground-fault circuit-interrupter. If replacement
of the plug is needed, use only identical replacement parts.
WARNING:
The unit is provided with a ground-fault circuit-interrupter
(GFCI)
.
To test the
GFCI
, push the test button. The GFCI should interrupt power. Push the reset
button.Power should be restored. If the GFCI fails to operate in this manner, the
GFCI
is
defective. If the
GFCI
interrupts power to the pump without the test button being pushed,
a ground current is flowing, indicating the possibility of an electric shock. Do not use this
pump. Disconnect the pump and have the problem corrected by a qualified service
representative before using.
CAUTION
-
To reduce the risk of electric shock the pool must be installed no
closer than 6 feet (1.8 m) from any electrical outlet. Do not place portable appliances
closer than 5 feet (1.5 m) from the pool.
WARNING:
The pump is not intended to be bonded to the equipotential
bonding grid.
DO NOT BURY CORD.
Locate cord to minimize abuse from lawn mowers, hedge
trimmers, and other equipment.
WARNING
-
To reduce the risk of electric shock, the supply cord cannot be replaced.
If the cord is damaged the appliance should be scrapped.
WARNING
-
To reduce the risk of electric shock, do not use extension cord to
connect unit to electric supply; provide a properly located outlet.
CAUTION
-
This pump is for use with storable pools only. Do not use with
permanently-installed pools. A storable pool is constructed so that it is capable of being
readily disassembled for storage and reassembled to its original integrity. A
permanently-installed pool is constructed in or on the ground or in a building such that it
cannot be readily disassembled for storage.
CAUTION
-
For continued protection against possible electric shock this unit is
to bemounted to the base in accordance with the installation instructions.
IMPORTANT
-
Using the pump with an unmatched electrical supply is
dangerous and will result in catastrophic failure of pump.
RISK OF ELECTRIC SHOCK -
When working with electricity, turn the electrical power off
at the circuit breaker and lock breaker door. Failure to do so will result in increased risk of
shock, injury and possibly death.
DO NOT REMOVE THE GROUNDING PRONG OR MODIFY THE PLUG IN ANY WAY.
DO NOT USE ADAPTOR PLUGS.
Consult a qualified electrician for any questions
related to the validity of your plugs grounding. Handle the pump with care. Do not pull or
carry the pump by the power cord. Never pull a plug from the outlet by yanking the power
cord. Keep cord free from abrasions. Sharp objects, oil, moving parts, and heat should
never be exposed to the filter pump.
NOTE:
Please examine equipment before use. Notify Bestway at the customer
service address listed on this manual for any manufacturing defect or missing parts at the
time of purchase. Verify that the equipment components represent the filter pump model
that you had intended to purchase.
NOTE:
Place pump on a solid and level ground. Pay attention to position of pool
and pump so adequate ventilation, drainage, and access for cleaning is available. Never
place pump in an area that may accumulate water, or in an area where foot traffic will
flow around the pool.
NOTE:
Atmospheric conditions may affect the performance and life span of your
filter pump. Unnecessary wear and tear may occur during periods of cold, heat and
exposure to sun. Whenever possible shelter the pump from these conditions.
NOTE:
Do not add chemicals in the filter pump.
NOTE:
Assembly and disassembly of this product should only be performed by adults.
• THERMALLY PROTECTED MOTOR CSA ENCLOSURE 3
• FOR USE WITH SWIMMING POOLS ONLY.
•
CAUTION:
TO ENSURE CONTINUED PROTECTION AGAINST SHOCK
HAZARD, USE ONLY IDENTICAL REPLACEMENT PARTS WHEN SERVICING.
•
WARNING:
RISK OF ELECTRIC SHOCK. CONNECT ONLY TO A
GROUNDING TYPE RECEPTACLE.
•
CAUTION:
THIS PUMP IS FOR USE WITH STORABLE POOLS ONLY -
DO NOT USE WITH PERMANENTLY-INSTALLED POOLS.
•
CAUTION:
CONNECT ONLY TO GROUNDING TYPE RECEPTACLE
PROTECTED BY A CLASS A GROUND FAULT CIRCUIT INTERRUPTER.
•
CAUTION:
FOR CONTINUED PROTECTION AGAINST POSSIBLE
ELECTRIC SHOCK THIS UNIT IS TO BE MOUNTED TO THE BASE IN
ACCORDANCE WITH THE INSTALLATION INSTRUCTIONS.
•
WARNING
-
RISK OF ELECTROCUTION
1) Connect Only To Properly Grounded Outlet. Do Not Remove Ground Pin
2) Inspect Cord Before Using – Do Not Use If Cord Is Damaged.
3) Keep Ground-Fault Circuit-Interrupter Dry And Off The Ground
4) Do Not Touch Plug With Wet Hands
5) Double Insulated – When Servicing Use Only Identical Replacement Parts.
6) Read Instruction Manual Before Using.
DO NOT REMOVE THIS TAG
SAVE THESE INSTRUCTIONS.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
WARNING:
Any changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s authority to operate the
equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/ TV technician for help.
4