1.
Unplug the pump.
2.
Remove the filter set from the spa.
3.
The filter cartridge can be rinsed off with a garden hose and reused. However, if the filter cartridge remains soiled and discolored,
the filter cartridge should be replaced. It is recommended to replace filter cartridge every three days depending on use.
4.
Replace the filter set in the spa.
When the spa is in use it is normal for internal air pressure to expand
and/or contract. When this occurs, air may leak from the air-valve on
the spa wall. Always check the air-valve carefully before use. If air is
leaking, use the provided wrench to fasten the air-valve following
these steps:
• Open the cap of the air-valve and put the wrench into the valve body.
• With one hand, hold the backside of the air-valve from the inner side
of the spa wall and turn the wrench clockwise.
Fasten the Air-Valve (For #54113, #54129 Only)
NOTE:
When performing chemical
maintenance, active the
Lay-Z-Massage function to quickly
dissolve chemicals into the water.
Do not use spa during chemical
maintenance.
NOTE:
Remove the chemical
floater from spa when the spa is in
use.
After performing chemical maintenance and before using the spa, use
a test kit (not included) to test the water chemistry. pH lower 7.4 and
over 7.6 will damage to the spa and pump. We recommend
maintaining your water pH between 7.4 and 7.6, total alkalinity
between 80 and 120ppm and free chlorine between 2-4ppm. Damage
resulting from chemical imbalance is not covered by the warranty.
All spas require the use of pool chemicals. Pool chemicals are
NOTE
:
1.
Do not over tighten.
2.
Always check the air-valve
carefully before use.
3.
Do not adjust the air-valve
connector when the spa is
in use.
potentially toxic and should be handled with care. There are
serious health risks from chemical vapors and the incorrect
labeling and storage of chemical containers. Please consult your
local pool supply retailer for more information about chemical
maintenance. Pay close attention to the chemical manufac-
turer's instructions. Spa damage resulting from misuse of
chemicals and mismanagement of spa water is not covered by
the warranty.
For Water Balance
1. As a guide, the water should be changed about every 3 days. This is only a guide; water quality is influenced by frequency of use,
persons using the spa and general maintenance.
2. Chemical maintenance: use pool chemicals to maintain water chemistry.
Use pool chemicals to maintain water chemistry and chlorine or bromine tablets (do not use granules) with the chemical floater.
Be sure to consult your local pool chemical supplier for information on treating the water in your spa and information on using the
chemical tablets.
Draining the Spa
NOTE:
Drawings for illustration purpose only.
May not reflect actual product. Not to scale.
S-S-002097
20
