303021238942_53350/53302/53346_14x21cm_
美规城堡说明书
_
英
3
ON/OFF SWITCH
OFF — O
ON — l
GROUNDING METHODS
Grounding Pin
Sketch A
Grounded
Outlet
Keep Unit Grounded:
Air blower should be grounded. In the event of an electrical
short circuit, grounding reduces the risk of electric shock by providing an escape wire
for the electric current. This product is equipped with a cord having a grounding wire
with an appropriate grounding plug. The plug must be plugged into an outlet that is
properly installed and grounded in accordance with all local codes and ordinances.
Warning:
Improper installation of the grounding plug is able to result in a risk of
electric shock. When repair or replacement of the cord or plug is required, do not
connect the grounding wire to either flat blade terminal.
The wire with insulation having an outer surface that is green with or without yellow
stripes is the grounding wire.
CAUTION:
Check with a qualified electrician or serviceman when the grounding
instructions are not completely understood, or when in doubt as to whether the air
blower is properly grounded. Do not modify the plug provided. If it will not fit the
outlet, have the proper outlet installed by a qualified electrician. The appliance must
be positioned so that the plug is accessible. If the supply cord is damaged, it must
be replaced by the manufacture or its service agent or a similarly qualified person in
order to avoid a hazard.
CAUTION - ELECTRICALLY OPERATED
PRODUCT:
NOT RECOMMENDED FOR CHILDREN UNDER 14 YEARS OF
AGE. AS WITH ALL ELECTRIC PRODUCTS, PRECAUTIONS
SHOULD BE OBSERVED DURING HANDLING AND USE TO
PREVENT ELECTRIC SHOCK.
KEEP CHILDREN AWAY:
Do not allow children to play with or around the unit, in any way, which could result in injury.
PROTECT POWER CORD FROM DAMAGE:
Never operate a unit with a damaged power cord, as this may lead
to electrical or fire hazards. If the power supply cord is damaged, it must be replaced by a cord of the same type and
amperage rating.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
• Warning: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/ TV technician for help.
OPERATION
Place the air blower on a steady net surface where children can be kept away. This air blower is for use on a nominal
120-volt circuit and has a grounding plug similar to the plug illustrated in sketch (A). Only connect the product to an outlet
having the same configuration as the plug.Do not use an adapter with this product.
