HOSS
™
Door Cart Installation Instructions
Install Door Cart Cover
Secure the doors and other components between
the dividers on the door cart. Drape the cover
over the parts stretching the elastic of the opening
around the components and down to the base of
the cart.
Remove Torx Bolts
Loosen and remove the Torx bolts from the door
hinge. The 2007 – Current Jeep Wrangler requires
a #50 Torx. Earlier Wrangler models may use a
13mm wrench.
Removing your Doors
To avoid costly replacement of parts,
please set aside all nuts, bolts and
other removable parts in a safe place for future
reinstallation.
Disconnect Door Strap / Cable
Disconnect the door restraining strap and any
wiring or cables plugged into the door. Depending
on the door type, you may need to refer to
the installation manual of the door for proper
disconnection.
Remove Door
To avoid injury or damage to the door, gauge the
weight of the door to the available strength provid-
ed. Some doors may need two people to remove.
With both hands, lift the door upward and out of
the hinges. If the door was factory installed, and
you are removing it for the fi rst time, shift the door
slightly back and forth to loosen the excess paint
inside the hinge.
Before installing the cover, make sure
items within the cart are secure.
Remove Bolt
from Bottom
Pull elastic
opening down
Elastic should fi t over the base when covering
2007 Wrangler and Wrangler Unlimited Full Doors
