TROUBLESHOOTING
SETTING UP APPLIANCE
1.
Stand the dispenser upright on a flat stable surface away from direct sunlight.
2.
Keep at least a 6-inch buffer zone between the dispenser and wall.
OPERATION
1.
Remove the label on the cap of a water jug.
2.
Insert the jug vertically into the top of the dispenser. Press the hot water switch until water flows from
the hot tap.
3.
Plug the dispenser into a wall outlet and turn on the hot/cold power switches behind the machine.
4.
The hot and cold indicators will light up when the dispenser is ready to use.
NOTE:
The dispenser will not operate until it has reached the proper temperatures.
CLEANING & MAINTENACE
•
After initial set-up, do the following:
1.
Let machine run for 30 minutes, then turn off power switches and remove the jug.
2.
Drain all water from the drain stopper and hot/cold taps (be careful of hot water).
3.
Replace the jug and run the hot tap until water comes out.
•
If using mineral water, you must clean the heating coil and tank by running a mixture of 2%
cooking-grade citric acid (or vinegar) and water through the machine at least once a month to prevent
mineral build-up.
•
After cleaning with the citric acid solution, run clean water through the machine to remove the citric
acid solution from the dispenser.
|
6
Water not being dispensed from
the taps
Water from the hot tap is not hot
or water from the cold tap is
not cold
Air vents are blocked
Remove the water jug
and readjust
The connection is not good
Unplug and setup away from
other objects/appliances
Make sure you are using a
grounded outlet and
leakage protector
Wait for water to adjust to
the proper temperature and
try again
Improper placement/setup
Too much water has been
used in a short amount
of time
The electrical connection
is loose
The water jug is damaged
Remove the jug and replace
with an undamaged one
Make sure power switches are
in the ON position and unit is
plugged in
Appliance is making a
loud noise
Water leakage
Electrical leakage
PROBLEM
REASON
SOLUTION
