Best BestReach BRR23030, Operation, Maintenance And Parts Manual, Page: 22 / 76

22
An emergency stop circuit controls electrical power to all parts of the conveyor. When any
one emergency stop switch or optional cable pull switch is activated, power is removed
from all motors and actuators stopping all movement of the conveyor frame and roller bed.
All electrical power is also removed from the motors and actuators when the DOOR
DISCONNECT HANDLE is in the OFF or OPEN positions.
ENERGIZE THE MASTER CONTROL CIRCUIT:
•
Make sure the door to the main electrical enclosure is closed and the DOOR
DISCONNECT HANDLE is in the ON position.
•
Both EMERGENCY STOP switches (one on the door of the MAIN CONTROL
PANEL and one on the OPERATOR’S PANEL) must be in their out position. If
depressed, twist the switch’s knob to allow it to return to the out position.
•
If the optional CABLE PULL stop switches are installed, both must have their
RESET BUTTON depressed and the cable pulls tensioned in their RUN position.
•
Press either RESET button (one on the door of the MAIN CONTROL PANEL and
one on the OPERATOR’S PANEL) to energize the master control circuit. The
CONTROL POWER INDICATOR light will be on when this circuit is energized.
MOVE CONVEYOR INTO POSITION:
•
Make sure the operator is the only person near the conveyor before moving it.
•
Make sure there are no obstructions in the path of the conveyor.
•
Push the joystick (located on the OPERATOR’S PANEL) down to drive the unit
forward into a truck. A bumper bar is provided on the discharge end of the
conveyor to stop the forward travel if there is an obstruction in the path of the
conveyor. Forward travel will stop when this bumper is depressed. The unit will
still drive in reverse with this bumper depressed. Pulling the joystick up will drive
the unit in reverse toward its parked position. Pushing the joystick to the
operator’s left will steer the unit to the left when it is traveling forward toward the
dock door. Right will move the conveyor right when traveling forward.
•
Releasing the joystick will stop the conveyor’s movement.
TURN ON CONVEYOR BED:
•
Check to make sure all personnel are away from the conveyor bed.
•
Press the BED ON/OFF button on the OPERATOR’S PANEL.
TO STOP THE CONVEYOR BED:
•
When the bed is running , press the BED ON/OFF button on the operator’s panel
•
Pushing either emergency stop button will stop conveyor and traversing motor.
Operating Instructions