1
Locate and Drill holes
for Z-Hangers.
2
Attach Z-Hangers
for mounting.
3
Hang board and mark bottom
4
Remove board and drill
5
Attach Lower Brackets and
Hang board
6
Secure Board
Determine board location. Measure from floor to
the top edge of board. Mark with pencil line the
corner location. Measure down from top edge of
board 1-5/8”, and draw line as shown. Locate
stud near each end of board and drill pilot hole
along line using 1/16” drill bit.
Hang board on
the Z-Hangers
using the Hanging
brackets mounted
on the back of the
board.
Draw line along
bottom edge of
board.
Secure board to bottom
brackets using 2 short
screws as shown.
Attach 2 Z-Hangers using 2 Long Screws as shown
Board Location
Board Location
1
5
8
Top Edge
of Board
Wall Stud
Draw line
Hanging Brackets on
back of board
1
1
8
Lift and remove board from the Z-Hangers.
Measure up from bottom line of board 1-1/8”, and
draw line as shown. Locate stud near each end of
board and drill pilot hole along line using 1/16” drill
bit.
Draw line
Board Location
Bottom Edge
of Board
Drill Hole
Secure 2 bottom brackets to the wall using 2 long
screws as shown.
Hang board on the Z-Hangers using the Hanging
brackets mounted on the back of the board.
P1 Board
1 EA
Parts List
Should you require assistance during
assembly, please call our Customer Service
Department
Monday - Friday 8 a.m. - 5 p.m. Central
Standard Time
Toll-Free Customer Service
1-800-749-2258
E300Px-T1_03/26/10
SPLASH CORK
E300Px-T1 Tackboard
Hardware List
A Z Hanging Bracket
2 EA
B Bottom Bracket 2 EA
C Long Screw 4 EA
D Short Screw 2 EA
E Screw Anchor-Concrete 4 EA
F Screw Anchor-Drywall 4 EA
