3
1.)
R
EAD
T
HROUGH
I
NSTRUCTIONS
FROM
BEGINNING
TO
END
BEFORE
STARTING
TO
ASSEMBLE
UNIT
.
Identify and Separate all the Parts and Hardware.
2.) Snap Connector (J) on each side of Board Assembly (P-1), line uo holes and
attach using one Screw (L) and one Tapped Rivet (K) as shown in Illustration #1.
Next attach Hinge Pivot (G) to each side of Board Assembly (P-1), remove
the two factory installed screws in the Connector clamp. Place Hinge Pivot (G)
over holes and tighten screws back as shown in Illustration #1A.
3.) Insert the Board Assembly (P-1) between the two Legs (P-2) and connect
using two Knobs (F) as shown in Illustration #1B. Leave the Knobs (F) loose.
3.) Attach the Top Cross Bar (P-3), it has two tapped Tray holes on one side of the tube, to the Legs
(P-2) using four Screws (A) and tightening with Allen Wrench (D). Repeat this Step to attach the
Bottom Cross Bar (P-4) to the Legs (P-2) using four more Screws (A) as shown in Illustration #2.
Illustration #1A
Illustration #2
A
P-3
P-2
P-4
P-2
Illustration #1B
G
P-1
F
P-1
Tray Holes
Illustration #1
J
K
L