4.4. Also adjust the distance of the side arms and pivot assembly according to desired width.
Align on both sides.
4.5. Tighten all the socket set screws on both the pivot shaft connector and pivot assembly
with the small hex wrench (J-2).
5.1. Slightly loosen the nut between the L-bracket and the Rubber Stopper bar. The L-bracket
should be loose enough to be moved but not loose enough slide on its own.
14
5. To adjust Rubber Stopper and setting L-Bracket angle
NOTE:
This comes pre-assembled correctly from the factory - this section included for your
reference only in the unlikely event that the wheel assembly goes out of line and needs to be
re-calibrated.
The same procedure applies
to all wheelchair sizes. Shown
above and below are images
of the wheel assembly for the
SitGo large.
