10
11
Lock the floor support with the locking bolt (14).
22-
(14)
Pull out the shoulder belt and make it into a loop (10a).
Thread the loop through the metal part of the red belt block
(10b).
Guide the loop into the red slit (10c).
Tighten the belt by pulling the top part down (10d).
Connect the anchor belts with the child seat. The anchor
belts must be crossed over.
Tighten the anchor belts to their maximum (13).
Positioned in the back seat of the vehicle, you should, if
possible, push the front seat of the vehicle backwards, so that
it is in contact with the child seat. If it is not possible to obtain
contact with the child seat, push the back rest of the front seat
of the vehicle forward so that the distance between child seat
and back rest of the front seat of the vehicle is minimum 25 cm.
15-
16-
17-
18-
19-
20-
21-
23-
(10)
a
b
c
d
(11)
(13)
Adjustments of the front seat might bring slack in the anchor
belts; tighten the anchor belts again.
If the seat is standing too upright: Push the front seat forward,
follow the described installation, by pulling the anchor belts as
much as possible before you lock the height of the foot support,
the car seat cushion will be compressed and you will achieve a
more reclined position for your child. Finally lock the foot support.
Practical Advice
!
(12)
!
Rearward-facing
in the
back
seat
Move the front brace outwards with
the ratchet. Continue tightening until
the brace is pressed well into the
back rest of the vehicle seat (12 ).
