BESAFE iZi Flex FIX i-Size, User Manual

Page: 4 / 8

12 13
Guarantee
• Should this product prove faulty within 24 months of purchase
due to materials or manufacturing fault, except covers and harness
straps, please return it to the original place of purchase.
• The guarantee is only valid when you use your seat appropriately
and with care. Please contact your retailer, they will decide if the
seat will be returned to the manufacturer for repair. Replacement
or return cannot be claimed. The guarantee is not extended
through repair.
• The guarantee expires when there is no receipt, when defects are
caused by incorrect or improper use, when defects are caused by
abuse, misuse or negligence.
• For the correct usage of the airbag in combination with the seat
read the vehicle handbook.
• Make sure the indicators are green before you drive.
• Make sure the back of the seat is touching the backrest of the
vehicle seat and the isofix connectors are pushed inside the seat
as far as possible. The red surface on top of the ISOfix release
handle must not be visible during driving.
• Make sure that the SIP bumpers are always connected with the
seat on the doorside and connected with the seat on the inner side
of the vehicle when there is enough space available.
! Warning: potential misuse
• Do take care when you remove the cover, as re-fitting the cover is
the reverse process.
• Start to take off the backrest part first and re-fit the backrest part
as the last part.
• For washing instructions, see the washcare label at the inside of
the fabric cover.
Removing and refitting the cover
Installation of 3 car seats
1. The SIP bumper on the inner side of the vehicle can be removed from
the seat to create more space next to the seat for an additional car
seat in the middle position of the vehicle. Remove a side bumper only
on the inner side of the vehicle and never on the door side. (24, 25)
2. To remove a SIP bumper, push the button and move the bumper
sideways and to the back, to hook it out of the fabric hooks. Keep the
SIP bumper for later usage. (26, 27)
3. To install a SIP bumper, first hook in the lower hook (28), then hook
in the upper hook (29) and finally secure the bumper in the middle
by pushing the button (30) first and releasing it when it’s positioned
against the seat. Check if the SIP bumper is connected correctly. Use
the SIP bumper always on the door side of the vehicle.